Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Abaqus - Contact Simulation. Unable to achieve contact

Status
Not open for further replies.

OmerSiddiqui

Mechanical
Jul 24, 2015
1
Hello everyone

I am new to this group. I am currently doing project on freewheel device and i am trying to simulate a contact model of freewheel mechanism using ABAQUS.

I have made the CAD on SolidWokrs and imported the assembly file (format : Parasolid *x_t). I followed the general procedures for simulating 'Surface-to-Surface' contact.

But so far, I am unable to achieve the contact. The models just simply pass by each other.
 
 http://files.engineering.com/getfile.aspx?folder=e3e012d5-00dc-4edc-b6c0-1b591734c1e0&file=test_model.cae
Replies continue below

Recommended for you

@Ice Breaker,

Even i looked at the .cae file myself and worked on it before, he has assigned normal contact to the model.

Nithin
 
Are the two objects too far apart to make contact so that it only appears that they are passing through each other because the displacements have been scaled up?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor