Abaqus coordinate system

[HayaNaji]

Hello guys
I have a problem in dealing withe the coordinate system in abaqus
when I sketch the section I want in the sketch module I set a specific point of the section at the origin
but when I use this sketch in the part module the position of the section changes.
how cn prevent this from happening, I want the position with refrence to the coordinates system to be the same in all modules and sketch ports
Notice the picture below for more illustration

I appreciate if anyone can help in this )

 

[Mustaine3]

In the 3D room create a CSYS in the origin first, so you can see where it is.
In the sketcher go into the sketcher option and reassign the origin of the grid to that CSYS.

 

[HayaNaji]

Sorry are you sure that option is available? , I can't Find it!

 

[Mustaine3]

See attached video.

 

[HayaNaji]

Thank you that was very useful