Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

about the rotation direction of dana axle

Status
Not open for further replies.

Busa20

Automotive
Aug 15, 2008
12
our company bought two dana axle, but I find the rotation direction of axle is different from the Conventional vehicle axle.
I attached a drawing and you can find the position of final reduction gear is not like Conventional vehicle axle's.
anybody has this experience?
 
Replies continue below

Recommended for you

What is your definition of "conventional" axle? What type of final reduction is your frame of reference?

rmw
 
thank you,rmw

as Conventional vehicle axle, we face to the input flange of rear axle,when the input is clockwise so the vehicle go forward.
but dana axle is On the contrary.

 
Flop the crown wheel over to the other side of the pinion.

Regards

eng-tips, by professional engineers for professional engineers
Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
 
This axle could have been for a rear engine drive vehicle like a bus is. But the solution presented by pat will solve it for you.

rmw
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor