I have an application where I have to detect a pneumatic guide cylinder at a pt on it’s travel. I also want to detect the location of 2mm after the first pt. As there may be the possibility of over-run of these two pts by about 10mm, I may side or flush mount the two sensors.
My question is,
How accurate, repeatable are inductive type barrel sensors when flush mounted as opposed to axial mounted ( or direct acting).?
Are they more accurate when axially mounted?
Can’t seem to find any data on accuracy from the manufacturers website.
Any comments welcome.
Speedy
My question is,
How accurate, repeatable are inductive type barrel sensors when flush mounted as opposed to axial mounted ( or direct acting).?
Are they more accurate when axially mounted?
Can’t seem to find any data on accuracy from the manufacturers website.
Any comments welcome.
Speedy