Adams/Car Anti-roll Bar

[giannis mavros]

Hello,

I am building a suspension geometry for the FSAE competition and I have a problem. The anti-roll bar does not work in the simulation. I have built the communicatoes and the joints but it does not work. Can anybody help? Thank you in advance!

 

[GregLocock]

Only a mind reader could tell from that post.

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376

http://eng-tips.com/market.cfm?

 

[giannis mavros]

You have a point! What I want to say is that the simulation shows errors that have to do with the antiroll bar joints.

 

[giannis mavros]

 

[Daniel Ursache]

Hi,

Did you overtake the issue ?
Long time ago I received same error, but take a look at the model from "acar". If I remember well, then it was something about deactivated mount parts.

Also check the matching name between CIL(R) and COL(R).

 

[giannis mavros]

Hello,

yes!It took me some time of checking and changing communicators and everything and then I found out that the problem was a missing fixed joint.
Thanks for the advice though!