Adding fillet between lofts 4

[ctopher]

Hi guys.
I'm back running on SolidWorks 2009 SP4 (after 3.5 years).

I have two lofts merging on a part. How can I select the edge between them to create a fillet? It wants to select the faces and I don't see an option for selecting the edge.
Attached is a .jpg.

Chris
SolidWorks 09, CATIA V5
ctopher's home
SolidWorks Legion

 

[Theophilus]

You might have a tough time getting the mold cavities to form with multiple/overlapping surface bodies like that. I've not tried it before, but it doesn't sound like something that would work without lots of manual attention and plenty of features.



Jeff Mowry

http://www.industrialdesignhaus.com

A people governed by fear cannot value freedom.

 

[ctopher]

I agree, thanks.

Chris
SolidWorks 09, CATIA V5
ctopher's home
SolidWorks Legion

 

[kellnerp]

Have you tried a face fillet for surfaces?
Have you tried the atomic bomb of fillets?

TOP
CSWP, BSSE

http://www.engtran.com

http://www.niswug.org

"Node news is good news."

 

[ctopher]

kellnerp,
I have not.
To fix the problem I added the fillet on the mold after it was created.
Thanks!

Chris
SolidWorks 09, CATIA V5
ctopher's home
SolidWorks Legion

 

[rollupswx]

To fix the problem I added the fillet on the mold after it was created.

Didn't you create the mold directly from the part?
I think I would figure out how to model the part.

 

[ctopher]

I modeled the part with the surfaces, then created the mold from the part. I was initially trying to add the fillet onto the part.

Chris
SolidWorks 09, CATIA V5
ctopher's home
SolidWorks Legion