Advanced Simulation - Constraints 1

[hpon]

Hi,

Struggeling with "overlapping constraints" in "Advanced Simulation". Seems like NX requires that individual constraints on adjacent surfaces (shared nodes on edges) must be defined in the same coordinate system (correct?). And I am not able to choose a specific coordinate system when I define the constraints, so I can't get the solver to run.

I'm stuck. Do you have any advice on how to apply different constraints on adjacent surfaces?

hpon

 

[obe0009]

Hello,

You can exclude the edge see attachment, maybe you have to fiddle with the selection toolbar (polygon edge)
to get it right.

Regards,

Olaf