Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Again about positioining form tools SW2003

Thread starter Petre
Start date Oct 19, 2004

Status: Not open for further replies.

Oct 19, 2004

Petre

Mechanical

I mention what somebody ask last year about positioining form tools, w/o any solution found on the forum.
In SW 2003 can't be control position for forming tool from palette features.When I give dimensions to the position sketch that has an uncontroled deplacement.
Thank you for any tip.