gifco
Civil/Environmental
- Jan 14, 2008
- 3
I am designing a 150mm HDPE sewer forcemain crossing of a marine harbour (1,500m)
There is an unfortunate hump of about 2.5m high that creates a high spot in the profile. This is without expensive trenching.
Are there suitable air release valves on the market that will operate in this environment?
The pipe at that point is only 9m deep and internal pressure about 20psi.
Thanks for any suggestions
There is an unfortunate hump of about 2.5m high that creates a high spot in the profile. This is without expensive trenching.
Are there suitable air release valves on the market that will operate in this environment?
The pipe at that point is only 9m deep and internal pressure about 20psi.
Thanks for any suggestions