Linghunt
Electrical
- Nov 10, 2014
- 5
Not sure if I'm over thinking this.
Material is 6061-T6 Aluminum for both parts. The Female thread is anodized Type II (MIL-A-8625) and I was considering having the Male thread anodized in Type III (hard coat).
Does the Type III buy me anything as far as galling is concerned for the added processing cost.
Is it a non factor as galling is concerned if anodizing is dyed or clear?
Material is 6061-T6 Aluminum for both parts. The Female thread is anodized Type II (MIL-A-8625) and I was considering having the Male thread anodized in Type III (hard coat).
Does the Type III buy me anything as far as galling is concerned for the added processing cost.
Is it a non factor as galling is concerned if anodizing is dyed or clear?