AMADA ENSYS

[lightl]

Does ENSYS 3015AJ open programs made for FO4020NT. The drawings for the same are not being generated in ENSYS 3i controller when opened via SDD. It opens perfectly fine in F04020 via SDD. But when the same program is opened in ENSYS via SDD(connected to the same server as FO4020NT), it fails to generate the drawing. Is it because the length and breadth of ENSYS being smaller as compared to FO4020?

 

[LaserEngine]

I would say no.
Probably also different G-code etc.

 

[lightl]

PS: The file generates the drawing if I take a NC output.ie. when the file is accessed via pendrive.

 

[lightl]

Apparently if you change the clamp information of the machine(FOM2) you can open the same program in ENSYS