Anchorage to Concrete According to British Standards

[saadpervez1]

Hi,
Can anyone guide me to the sections of British Standards similar to Appendix D: Anchorage to Concrete of ACI codes.

I need to compare the pullout and breakout strength provisions of ACI and BS.

Thank You

 

[Agent666]

Not aware of anything specifically in British standards, but this is applicable to European practices.

Link

 

[prasadrmb]

Please refer following links to get the knowledge about anchorage and blond stresses.
Simplified methods of obtaining the anchorage length and method of manual calculating with example can be seen through following links

http://structuraldesignbs.blogspot.com/search/label/Anchorage Bond Stress

http://structuraldesignbs.blogspot.com/search/label/Lap and Anchorage

 

[Trenno]

Look up Hilti's methods according to ETAG.

Gold standard in anchor design and testing, or so I am lead to believe.

 

[saadpervez1]

Thank you all.

I have used this ETAG document, found for free here:

http://www.aedilitia.itc.cnr.it/documenti/020-annexC.pdf

I normally use Appendix D of ACI 318-11 but the consultant demanded Eurocode based calculations for a specific project. Thank you for your help.

 

[bkal]

There is a Draft for Development document:
Design of fastenings for use in concrete, Part 4-2 Headed Fasteners,DD CEN/TS 1992-4-2:2009.

You can also refer to:

CEB 233, Design of fastenings in concrete