Aug 11, 2023 #1 SiggiN Marine/Ocean Mar 18, 2019 33 0 0 NO Hi! Suppose you have a flange connection as shown below Would you exclude the surface area of the bolts on the "inside" of the bolt holes, when calculating required anode mass? Is such an exclusion supported by DNV-RP-B401? Regards Siggi
Hi! Suppose you have a flange connection as shown below Would you exclude the surface area of the bolts on the "inside" of the bolt holes, when calculating required anode mass? Is such an exclusion supported by DNV-RP-B401? Regards Siggi