Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ANSI Y14.5-2009

Status
Not open for further replies.

PhoenixDynamometer

Industrial
Jan 6, 2011
97
Hello all,
I was looking for the new GD&T symbols introduced in ANSI Y14.5-2009 that have been around for a few years now but they do not appear to be in SW yet. Is this the case or am I just missing them.

Thanks,
PD


Home of the world's most accurate and repeatable dynamometers, dynamometer accessories, and data acquisition & control software.
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor