Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys 12.1 Error SIGSEGV

Status
Not open for further replies.

benjablas

Mechanical
Sep 5, 2010
2
CL
Hello
I´m modelling a hyperelastic material in Ansys 12.1. I have the uniaxial test data and I´m doing a curve fitting. After I did this and started modelling the problem, an error finished my simulation. It was "An unknown error has ocurred (SIGSEGV)..." and then something about termination abnormally. I think this error has something to do with my Windows XP 32 bit system. Somebody could tell if this is?
Thanks
 
Replies continue below

Recommended for you

This is not really a polymers problem. The software fora or tech-tips might be a better place to seek advice.

Regards
Pat
See FAQ731-376 for tips on use of eng-tips by professional engineers &
for site rules
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top