ANSYS 13 Workbench, change default coordinate system

[SverkerO]

In ANSYS 13 Workbench the default vertical up axis is Y. Is there away to change it to Z? The reason for asking is that I use the num keys to rotate the model. And because I use Z as vertical up in my modelling the num keys don't work as intuitive as they would if Y was vertical up.

I.e. my question is rather is there a checkbox for Z as vertical up rather than how do I rotate...

Best regards

 

[fuzzdoug]

would re-mapping the keys work as well?
i believe you can set shortcut keys in the workbench options.