Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys to abaqus

Status
Not open for further replies.

FEA_User

Automotive
Jan 27, 2022
29
Hello,
Please i'm asked to do the same simulation as in attached file with Abaqus,so i'm looking for someone who can help me to find the right Ansys-Abaqus equivalence of the boundary conditions, loads, contacts...
Thanks for help
 
 https://files.engineering.com/getfile.aspx?folder=a7c8f9e4-d868-4c70-a9d3-86793e1c39f8&file=20221212_Ansys_-_Stress_analysis_Step_by_step_V2-rev.pdf
Replies continue below

Recommended for you

KCM5

I guess its simple rotor analysis using static structural analysis approach except the electro magnetic part. This can be done using static analysis option in Abaqus. I can only provide you a hint since no access to Ansys. There are no special type of constraints in Abaqus e.g. Cylindrical support or frictional support. You need to look at each boundary condition information in Ansys documentation about which and how many DOF's are restricted and how. You can then use this information to setup this problem in Abaqus.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor