max62niers
Mechanical
Hello everybody,
I would need an hand for a little trouble a got when running an explicit dynamic simulation with ANSYS workbench.
I have a very simple model to which I apply a vertical velocity in order to measure the impact versus a fixed sheet of metal.
What is weird is that I could run the analysis without any trouble, but then when changing the geometry of the moving part I've got this error :
"An error occurred when the post processor attempted to load a specific result. Please review all messages."
I came back to the first geometry which was running perfectly and once again I have the same error and impossible to run the model again..
Could someone help me on this?
Thanks!
Maxime
I would need an hand for a little trouble a got when running an explicit dynamic simulation with ANSYS workbench.
I have a very simple model to which I apply a vertical velocity in order to measure the impact versus a fixed sheet of metal.
What is weird is that I could run the analysis without any trouble, but then when changing the geometry of the moving part I've got this error :
"An error occurred when the post processor attempted to load a specific result. Please review all messages."
I came back to the first geometry which was running perfectly and once again I have the same error and impossible to run the model again..
Could someone help me on this?
Thanks!
Maxime