Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ansys Workbench Constraints Help

Status
Not open for further replies.
femboy

femboy

Mechanical
Mar 11, 2009
29
TR
Hello, I want to ask about contraints Ansys WB. My problem is ; Contsraint region is'not free at -Z direction, But It's free at +Z.And X,Y free. Thank you.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
You could try a Body-Ground Joint and setup Stops.

Sounds like a "Compression Only" constraint could work.
It is non-linear, but should work.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

struclearner
  • Locked
  • Question
Reaction Force Distribution in ANSYS Workbench!
Replies
0
Views
35
struclearner
struclearner
IJR
  • Locked
  • Question
Ansys workbench structural:Two load steps different large displacement settings?
Replies
0
Views
20
IJR
IJR
TeoAlfa
  • Question
ANSYS Mechanical - Concrete embedded steel components
Replies
0
Views
48
TeoAlfa
TeoAlfa
md_salem
  • Locked
  • Question
how to do share topology in the design modeler in Ansys Workbench
Replies
1
Views
17
Stick.
Stick.
IJR
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
43
IJR
IJR

Part and Inventory Search

Sponsor

Back
Top