Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations The Obturator on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Anyway to disable the ability to shut off "Convert Primary Tolerance..

Status
Not open for further replies.
ingallspw

ingallspw

Mechanical
Mar 17, 2009
178
This is another silly question...

Why is there even an option to 'not' "Convert Primary Tolerance to Secondary Units" and why is it shut off (especially) by default?

Is there anyway to never unselect this option even if it has already been "selected" (by default) in a saved document?

Thanks again!!

Keegan
 
Status
Not open for further replies.

Similar threads

CAD2015
  • Question
Is it possible to convert cgm to drawing? 1
Replies
2
Views
1K
CAD2015
CAD2015
Asieros
  • Locked
  • Question
Siemens NX Drafting - Reset the "Border to Arrow Distance"
Replies
0
Views
442
Asieros
Asieros
MANox
  • Locked
  • Question
Change tabs bar posiotion to "centered"
Replies
2
Views
211
MANox
MANox
DDerek
  • Locked
  • Question
How to make "Balloon" Result in only the number for the callout
Replies
3
Views
202
SDETERS
SDETERS
Anton Liubimov
  • Locked
  • Question
NxOpen, How to programmatically open a dialog box "Extrude"
Replies
2
Views
396
Anton Liubimov
Anton Liubimov

Part and Inventory Search

Sponsor

Back
Top Bottom