JUICESEAUS
Industrial
- Jun 17, 2009
- 2
Inventor series 11.
I have been using this program for a couple years now, and never had this issue. The feature to have the dimension box automatically open for manual input in part sketch mode, does not want to maintain its setting. I have manually adjusted the application settings under tools, in the sketch tab and the minute I return to my drawing it is as if I haven't done anything...oh yeah, apply and close all as normal. I go back to the settings and the check box is in fact "unchecked" again.
Thanks for any input.
j
I have been using this program for a couple years now, and never had this issue. The feature to have the dimension box automatically open for manual input in part sketch mode, does not want to maintain its setting. I have manually adjusted the application settings under tools, in the sketch tab and the minute I return to my drawing it is as if I haven't done anything...oh yeah, apply and close all as normal. I go back to the settings and the check box is in fact "unchecked" again.
Thanks for any input.
j