Apply Moments in Solidworks Simulation

[IdanPV]

Hello all,

I would like to know what is the best way to apply moment acting on a nozzle attached to a pressure vessel.
For example, what is the correct way to apply the moment in the figure below on the nozzle, using Solidworks Simulation:

https://res.cloudinary.com/engineering-com/image/upload/v1721159716/tips/Nozzle_hchd3q.png

or here:

http://www.piping-engineering.com/wp-content/uploads/allowable_nozzle_loads.jpg

Thank you for your help

 

[FEA way]

You can use the Torque load type to apply moment directly to a face.

 

[IdanPV]

Thank you very much