Arrow label of the detail view 2

[cubalibre000]

Hi to all,
Is it possible change the position of the arrow indicated ?

Thank you...

Using NX7.0 and TC8.1

 

[MickyV007]

YES, hold down the SHIFT-key then drag the arrow to the disered place with left mouse button.

Best regards,

Michäël.

NX4.0.4.2 MP10 + TCE 9.1.3.8_build_0711 / NX6.0.5.3 + TC8.1 Unified / NX7.0.0.9 (native) / NX7.5.1.5 (native)

Belgium

 

[cubalibre000]

Perfect...

Thank you...

Using NX7.0 and TC8.1

 

[jerry1423]

and note that when the size of the circle is specified (with a screen pick) in the parent view, the arrow pointing at the circle will be at that point - but from there you can more the arrow as specified above.
So in the example that you showed - if the point used for the size of the circle was a screen pick 180 degrees from where you put it, you would have been in much better shape that where you were.