ASEMBLY RELATIONS

[coolbe]

SCENARIO:
I set relations to my generic asembly. I want to use the
same relations in an instance asembly, but I am getting same values.
Can anyone help?

 

[yogeshb]

The notation use to enter relation in assembly mode are differes from the notaion use to enter in parts mode.

In assembly mode, for each assembly parameter, you must specify a "session_ID" that refers to a component in the assembly.

Session ID can be get from relation menu.

For example, parameters in an assembly appear for part with session_ID 1 as d0:1, d1:1 etc where as for part with session_ID 3, they appear as d0:3, d1:2 etc

Hope this will throw some light on your requirement.

Cheers...

Yogesh Birari

 

[helpmewithintralink]

Coolbe, This is discussed in full detail in the documentation. It is pretty complete. Give it a read and let me know if you have a specific question.
Good point yogeshb, There is the session_ID, but, I prefer the component_ID. A former Pro/GENIUS taught me this to avoid having identicle session ID'd in a larger assemlby.