ASME 80:10 Flanged and Dished heads

[9485]

Where in the Code can I find the dimensions for 80:10 Flanged and Dished Heads ?
I know the outside radius of dish sould be 80% of the outside diameter of the Head and the Inside knuckle radius should be 10% of the outside diamenter of head.
But I need the code support and I can't find it.

thank you!!!

 

[blackwed]

Look thru these guys' stuff.

http://www.pveng.com/Charts/Charts.htm

DB

 

[MJCronin]

9845...

I am not really sure what your question is, but 80:10 heads have been around for a long time.

They are commonly applied in cases where the material cost is very high (e.g. titanium, C276 etc)and an optimum head design (thinnest head) is desired

Contact these people:

http://www.northlandstainless.com/tools/volume_calculator.php

More good info on:

http://www.brightontruedge.com/pdf/80-10.pdf

tell us more about your project....

Why do you want an 80:10 head for your vessel ????

-MJC

 

[JoeTank]

You need to go to Appendix 1 for the equations for an 80-10 head.

Steve Braune
Tank Industry Consultants

http://www.tankindustry.com