Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME B31.3 1

Status
Not open for further replies.
redandysafc

redandysafc

Mechanical
Dec 18, 2005
60
Does anybody know of anywhere in ASME B31.3 that states hardness testing and impacts are required for procedures.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Refer to Chapter III 323.2.2 and 323.3 and Chapter IV 328.2.1(d)for impacts testing. Hardness test requirements are for production welds per 331.1.7. Many Owners/Engineers will specify hardness testing for procedure qualification to meet the Table 331.1.1 requiremnts.

 
Upvote 0 Downvote
Thanks Stanweld . So does that mean I have to do impact and hardness tests on cunifer 70/30.
 
Upvote 0 Downvote
More than likely no impact testing will be required. See Table 323.2.2 A-6 and B-6. Impact testing is not required at design temperature > or = to -325 F.

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

FOX70N
  • Locked
  • Question
ASME B31.3 1
Replies
1
Views
160
DekDee
DekDee
mrpsi
  • Locked
  • Question
Qualifying A4-70 bolt per ASME B31.3
Replies
2
Views
259
mrpsi
mrpsi
Mustakim
  • Locked
  • Question
ASME B31.3 Impact testing for SS304 with MDMT of -165degC
Replies
0
Views
314
Mustakim
Mustakim
LB_FLO
  • Locked
  • Question
Weld Repair ASME B31.3 1
Replies
10
Views
671
DekDee
DekDee
Metallurgistrbi
  • Locked
  • Question
ASME Sec.8 Vs ASME B31.3
Replies
2
Views
123
Metallurgistrbi
Metallurgistrbi

Part and Inventory Search

Sponsor

Back
Top Bottom