Feb 8, 2012 #1 LCeballos Mechanical Jan 19, 2012 29 Is it accepted to fabricated a tubesheet from casting, for example: SB-369-96400 instead of plate SB-171-71500? Thanks in advance
Is it accepted to fabricated a tubesheet from casting, for example: SB-369-96400 instead of plate SB-171-71500? Thanks in advance
Feb 8, 2012 1 #2 fegenbush Mechanical Apr 5, 2006 783 Per Section II-B, the only acceptable UNS number is 96200, but yes, castings can be used per Section VIII-1 UG-7. Weldability is a concern with some alloys. Check with the appropriate material standard to see if special precautions need to be taken. Upvote 0 Downvote
Per Section II-B, the only acceptable UNS number is 96200, but yes, castings can be used per Section VIII-1 UG-7. Weldability is a concern with some alloys. Check with the appropriate material standard to see if special precautions need to be taken.
Feb 8, 2012 1 #3 SnTMan Mechanical Jan 22, 2005 6,785 LCeballos, assuming you ARE working to Sec VIII, Div 1, you should also review Part UNF. Regards, Mike Upvote 0 Downvote
LCeballos, assuming you ARE working to Sec VIII, Div 1, you should also review Part UNF. Regards, Mike
Feb 8, 2012 Thread starter #4 LCeballos Mechanical Jan 19, 2012 29 Thanks a lot guys! Upvote 0 Downvote
