ASME requirement for 100% RT for stainless steel plates above 38mm

[jbesson]

Hi dears Specialists

I have in mind a requirement from ASME VIII div 1 about 100% RT for stainless steel plates above 38mm.
I have been able to found the UCS-57 § for CS and the limit of 32mm but impossible to find the § dealing with the limit for stainless steel in the UHA...

Do I start to loose my mind ?

Thanks in advance !

 

[SnTMan]

jbesson, see UW-11, UW-33 Sorry, UHA-33 [headsmack]

Regards,

Mike

The problem with sloppy work is that the supply FAR EXCEEDS the demand

 

[jbesson]

Fine, thanks Mike !

 

[r6155]

You were thinking of using E = 0.7 or 0,85 for SS plates above 38 mm ?

Regards