Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME SC VIII Div.1 UW-17(f)(1)

Status
Not open for further replies.
pvesseleng

pvesseleng

Mechanical
Dec 19, 2004
51
Is it the intent of ASME SC VIII Div.1 UW-17(f)(1) welder stamp can not be applied at -40ºC for ferrous materials.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I believe you meant UW-37 (f). Yes, -40 deg C is too cold for stamping ferrous materials in accrodance with UW-37 (f). Stamping can be done provided you have ferrous materials limited to P-No 1 Groups 1 and 2, with a MDMT at or above -29 deg C. In lieu of stamping, the manufacturer must maintain a record of the welders ID and location of their welds.
 
Upvote 0 Downvote
pvesseleng
did you mean -40°C MDMT

Putting Human Factor Back in Engineering
 
Upvote 0 Downvote
yes I meant -40°C MDMT. sorry for bad question.
Thanks
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jayinwww
  • Locked
  • Question
ASME Sec VIII Div 1 full pen weld on a mixer 1
Replies
4
Views
393
weldstan
weldstan
M
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
2K
Mecat24
M
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
679
teokal
teokal
wdavidchris
  • Locked
  • Question
ASME VIII Div.1 - Hydrostatic Test Pressure for A240 304/304L 1
Replies
9
Views
348
EdStainless
EdStainless
victor6397
  • Question
Peak stress in shell elements ASME VIII div.2 1
Replies
2
Views
581
victor6397
victor6397

Part and Inventory Search

Sponsor

Back
Top Bottom