Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ASME SECTION VIII DIV I ECCENTRIC HOLES IN HEADS

Status
Not open for further replies.
RandyManC

RandyManC

Mechanical
Sep 12, 2012
1
Which UG should I reference to determine how close I can place an eccentric hole in a head? Head is a cap welded inside end of 10" pipe the hole is a 2 1/2" diameter coupler that will be welded into head?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
If it is single opening, there is no restriction. Please explain "how close to what", you want locate the nozzle?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question
ASME Section VIII Division 2 - Protecion Against Local Failure
Replies
6
Views
3K
antoniol
A
M
  • Question
SCL Placement for Fillet Welds in ASME VIII Div. 2 DBA
Replies
10
Views
2K
Mecat24
M
victor6397
  • Locked
  • Question
Peak stress in shell elements ASME VIII div.2 1
Replies
2
Views
615
victor6397
victor6397
A
  • Question
5.4.2. Buckling analysis - Method A - ASME Section VIII Division 2 - negative EigenVaue
Replies
1
Views
194
TGS4
TGS4
teokal
  • Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
990
teokal
teokal

Part and Inventory Search

Sponsor

Back
Top Bottom