BlazPlestenjak
Mechanical
- Dec 1, 2021
- 11
Hi,
For the past few months I've been trying to implement our Formula Student suspension into Adams Car FSAE template. Our formula car has so called decoupled suspension, so i had to make my own templates for front and rear suspension and ARB. My assemby behaves very weirdly and I cannot pin-point the problem.
For example:
I ran an accleration test. At the second increment simulation stops. To exaggerate the problem, I have increased the error number and number of steps. Result of the acceleration is shown on the pictures below. Car accelerates and the suddenly turns. Car has the tendency to steer (don't know if steering is the problem) into one direction.
When I tried to simulate hand free test, car drives foward with slowly turning to the right. I am attaching link to adm and msg files of the acceleration test I ran:
Has anyone seen anything like that before? I am really desperate to finish this project.
Please help!
For the past few months I've been trying to implement our Formula Student suspension into Adams Car FSAE template. Our formula car has so called decoupled suspension, so i had to make my own templates for front and rear suspension and ARB. My assemby behaves very weirdly and I cannot pin-point the problem.
For example:
I ran an accleration test. At the second increment simulation stops. To exaggerate the problem, I have increased the error number and number of steps. Result of the acceleration is shown on the pictures below. Car accelerates and the suddenly turns. Car has the tendency to steer (don't know if steering is the problem) into one direction.

When I tried to simulate hand free test, car drives foward with slowly turning to the right. I am attaching link to adm and msg files of the acceleration test I ran:
Has anyone seen anything like that before? I am really desperate to finish this project.
Please help!