smallzer
Industrial
- Nov 11, 2003
- 3
Hi Guys,
We're cutting 316 S/S (6mm) @ 2mtr/min using Oxygen assist gas. We've now been told that we can't have any oxidation on the product which means changing gases. Unfortunately Nitrogen will slow us down too much. Does anyone know if an assist gas mixture would help. I.e. could we still cut faster than Nitrogen with say a Nitrogen/Hydrogen mix?
We're cutting 316 S/S (6mm) @ 2mtr/min using Oxygen assist gas. We've now been told that we can't have any oxidation on the product which means changing gases. Unfortunately Nitrogen will slow us down too much. Does anyone know if an assist gas mixture would help. I.e. could we still cut faster than Nitrogen with say a Nitrogen/Hydrogen mix?