Assy configuration

[Mxious]

Hi it's me again !!

Is there a way to made different set-up of the same assy and put it into a draft ?

Ex. Suppose I have a door who move with a cylinder. I want to make 2 view in a draft in the two position:
Door closed (cylinder out)
Door opend (cylinder in)

But I wont delete my constraints, create 2 assy or anything like this.

Please help !

 

[donyoung]

I would suggest to use 'Alternate Position' assembly for that.
You should find a description in SE's help

dy

 

[PatCouture]

Donyoung you're right on as always!

The way I normally do this is to create the cylinder as an Alternate position assembly so I have the cylinder position retracted and extended available, then I use it to control the position of the door in an Alternate position assembly of the door itself.

I hope my explanation is not too confusing!

Pat

 

[Mxious]

Hi PatCouture !

Are you speaking french ? Si oui j'aimerais communiquer avec toi pour des question plus technique sur SE !!


A+

 

[PatCouture]

Salut Mxious!

Tu as reconnu mon accent

Mon courriel est le pro-machpatrickc (arobase) videotron.ca

Ça va me faire plaisir.

Patrick