Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AUPREC

Status
Not open for further replies.
boldfish

boldfish

Mechanical
Joined
Jan 29, 2003
Messages
101
Location
US
Angular Unit Precision setting. What is it for?
The Linear counterpart setting is reflected when using DIST command. Where would I see the results of the AUPREC?
 
Sort by date Sort by votes
when you list an entity the angular result will change with this setting ie:line angles, arc start and end etc
 
Upvote 0 Downvote
Used usually to control accuracy when programming autocad. If the precision is low, drawing lines emanating from a point to the next point, to the next point, etc... and then back to the beginning may be off.

"Everybody is ignorant, only on different subjects." — Will Rogers
 
Upvote 0 Downvote
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top