I am trying to set up my fonts when in model/ assembly sketch mode so that the fonts always stay the same size relative to the screen and not the model (i.e. when you zoom in the text physically stays the same size compared to the screen and does not magnify when you zoon and in the same way that the relation symbols do not change size when you zoom.). I know there is a way to do it (because I have some dimensions that behave like this) but I cannot find out how to do it. Since I installed ST5 I have not been able to get this function back for new dimensions that I add. Can someone give me any help on this please? Many thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Auto font scaling
- Thread starter tkane51
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question