autoballoon issue 1

[vitulin]

Hi,

I wonder if you could help me. Imagine that you have a drawing with balloons according to the parts list. It will only show one balloon for every component type. Is it somehow possible to change the settings so, that it would show all the occurences of the current part?
I am using NX 4.02
Thanks for help
Vit

 

[JohnRBaker]

NO.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[vitulin]

not good (

 

[JohnRBaker]

Now there's nothing stopping you from going into the other views (which I assume is the issue here) and manually add as many ID balloons (don't worry about the callout value, just leave it blank) as needed (once in the ID Symbol dialog, it takes only 2 picks per ID balloon to select the component and place it). Once done, go back up and select/highlight the parts list, press MB3 and select the 'Update Parts List' item and the new ID balloons will automatically be populated with the proper item callout letter/number.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[vitulin]

This sounds much better )

Thanks John

Regards
Vit