Autoclave Beginner - need suggestions

[Flashoflight]

Our company has purchased a 48" x 20' autoclave to cure extruded rubber shapes. I am looking for some good information (book or article) on the setup of an autoclave, controls, and safety.

Steve

 

[gr2vessels]

If it is a standard, off shelf autoclave, the set-up and controls are detailed in the little booklet attached to the guarantee sheet, together with the list of your nearest repair shop.
Otherwise, you might have to disclose to this forum the make and model of your autoclave, if you are really expecting some advice.
Cheers,
gr2vessels

 

[SnTMan]

Or maybe even contact the manufacturer.

Regards,

Mike

 

[PVinspector]

I am looking for some good information (book or article) on the setup of an autoclave, controls, and safety.

Don't open the door when it is under pressure