Cameron Spence
Mechanical
- Jun 15, 2018
- 1
Hey All,
New to this forum site in search of some advice / opinions! If this is not the right thread, I'll take any suggestions. I've been designing sprinkler systems using HydraCAD software with AutoCAD for about 4 years. I initially liked the program, but I have grown frusterated with the inability to draft in 3D, especially when it comes to standpipes and basic risers. I end up drawing all my risers in elevation view, and it can get messy going back and forth and "jumping" from location to location when exporting for calculations. Any thoughts or experiences with AutoSprink? Thank you in advance!
New to this forum site in search of some advice / opinions! If this is not the right thread, I'll take any suggestions. I've been designing sprinkler systems using HydraCAD software with AutoCAD for about 4 years. I initially liked the program, but I have grown frusterated with the inability to draft in 3D, especially when it comes to standpipes and basic risers. I end up drawing all my risers in elevation view, and it can get messy going back and forth and "jumping" from location to location when exporting for calculations. Any thoughts or experiences with AutoSprink? Thank you in advance!
