Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

axels hub

Status
Not open for further replies.
andouro

andouro

Structural
Aug 28, 2006
6
which the difference between axles with cubes lubricated with oil seaded or lubricated with grease
 
Replies continue below

Recommended for you

Sort by date Sort by votes
In general, oil is for high-speed applications; grease is for low-speed applications. Oil requires a higher speed to build up hydrodynamic pressures and float the journal. Grease is semi-solid and can support a slow-moving load due to shearing action in the lubricant.

Hope this helps.

Don
Kansas City
 
Upvote 0 Downvote
OK, AND IF THE AXLES WORK WHITH TEMPERATURE -40ºDEG TO +40ºDEG ?


Best regards,
 
Upvote 0 Downvote
Consult the temperature recommendations for the lubricant.

Don
Kansas City
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Venky_Enggy
  • Locked
  • Question
Taper Shaft and Hub interference Calculation
Replies
11
Views
683
GregLocock
GregLocock
Indy
  • Locked
  • Question
Techlok vs Graylok hubs
Replies
4
Views
369
Indy
Indy
Helepolis
  • Locked
  • Question
Creating a Hub for a D-shaft 6
2
Replies
25
Views
181
Helepolis
Helepolis
engineer_ag_t
  • Locked
  • Question
Hexagon Shaft-Hub-Connection 1
Replies
2
Views
72
tbuelna
tbuelna
gtsolid
  • Locked
  • Question
Torque generated by hub deformation 1
Replies
1
Views
27
jlnsol
jlnsol

Part and Inventory Search

Sponsor

Back
Top Bottom