Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Axisymmetric model with both axisymm and not axisymm loads

Status
Not open for further replies.
gelsomino

gelsomino

Mechanical
Joined
Jan 24, 2005
Messages
8
Location
IT
Hi. Is there anyone who can tell me how to load a plane 25 model with axisymmetrical load (mode 0) and with non axisymmetrical load (mode 1 isim 1)? How can i combinate these two loads with the result of a thermal analysis (made with PLANE55)?

Thanks a lot.
 
Sort by date Sort by votes
It's actually pretty clear in the help. Check out the help for PLANE25 and the Element Reference Manual, Arcticle 2.13.

Good luck!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

S
  • Locked
Concrete Shrinkage modelling with ANSYS
Replies
1
Views
2K
crshears
crshears
Ahmed_abdelgawad
  • Question Question
CDB and ‘prnsol,s’
Replies
0
Views
4K
Ahmed_abdelgawad
Ahmed_abdelgawad
T
  • Question Question
Accessing Named Selections of Contact Surfaces via CMSEL After Applying Condensed Geometry Not Possible
Replies
0
Views
4K
TOM1345
T
vickyiamlucky
  • Locked
  • Question Question
Ansys Symmetry model to full model cut boundary dispacemnt or force bc
Replies
0
Views
721
vickyiamlucky
vickyiamlucky
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W

Part and Inventory Search

Sponsor

Back
Top