lerk
Industrial
- Dec 1, 2010
- 1
I am looking to bend 30mm pipe into U shapes with a radius of about 95mm. Normally get them manufactured for us on a mandrel bender but for cost reasons we would like do it our selves. We are manufacturing in the 1000s so need fairly good output.
Mandrel benders are outside my budget, apart from the tool which i would have to buy is there more to a madrel bender than a shaft that turns through 180 degrees. which i could make my self with hyraulics.
any thoughts
Mandrel benders are outside my budget, apart from the tool which i would have to buy is there more to a madrel bender than a shaft that turns through 180 degrees. which i could make my self with hyraulics.
any thoughts