Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Bolt Tensioning Conversion

Status
Not open for further replies.
nco2612

nco2612

Mechanical
Feb 17, 2005
8
We have a bolt tension to apply of 1800Nm. The torque equipment we will hire will be calibrated in bar(g) or psi. Does anyone know how to convert torque setting into the reference psi/bar figure.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

kremenco
  • Locked
  • Question
Calculation of Anchor Bolt Diameter/ Length for Pressure Vessels 1
Replies
3
Views
351
kremenco
kremenco
jtravs
  • Locked
  • Question
Combining different bolt sizes on a flange 2
Replies
16
Views
329
pperlich
pperlich
GAL02
  • Locked
  • Question
BOLT TENSIONING 1
Replies
13
Views
269
GD2
GD2
klliq
  • Locked
  • Question
Bolt pressure through two flanges. 1
Replies
17
Views
370
klliq
klliq
VFK
  • Locked
  • Question
Target bolt stress for a double gasket flanged joint - ASME PCC1 1
Replies
3
Views
205
XL83NL
XL83NL

Part and Inventory Search

Sponsor

Back
Top Bottom