Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Break line
- Thread starter loka23
- Start date
You can change that in the Customer defaults.
But most probably there is a tiny element in your sketch. Did you create the sketch from imported curves?
You can use the Examine Geometry to check for tiny objects.
Tiny elements could also be created during trim actions in the sketcher.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
But most probably there is a tiny element in your sketch. Did you create the sketch from imported curves?
You can use the Examine Geometry to check for tiny objects.
Tiny elements could also be created during trim actions in the sketcher.
Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
Building new PLM environment from Scratch using NX12 / TC11
- Thread starter
- #3
- Status
