Break out section in a sectioned view?

[venomex]

I have a sectioned view and have one revolved part unsectioned.
I tried to create a break out section over this unsectioned part but i can see nothing. ie I cannot obtain a view of the inner section of that unsectioned part.

Am I doing something wrong or which is not possible in NX, or is there an alternative?

Shetty,
Using NX 10.0.1.4

 

[ewh]

There is a setting to allow taking a section from a section; it is not activated OOTB because it goes against ASME standards.

"Know the rules well, so you can break them effectively."
-Dalai Lama XIV

 

[venomex]

Any idea as to where to check/uncheck it?

Shetty,
Using NX 10.0.1.4

 

[64polara]

Have you tried changing setting for the breakout for cutting thru or not cutting thru the model, or changed your vector direction of cut?
just a thought.

Wayne Huseby
Drafting Checker
Goodrich Corp
Jamestown, ND 58401

 

[NutAce]

Isn't the unsectioned property of part also blocking the break out section?


Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[venomex]

@ Wayne, I've tried the cut through part Option and changed the vectors, but no success. It does not Show the break out section.

@ Ronald, I dont think the unsectioned part will block the non-sectioned part. My assembly is something like Image attached

Shetty,
Using NX 10.0.1.4

 

[venomex]

So I've sectioned view of the cuboid and other parts along center,
Unsectioned the cylinder with hole
Tried to Show a break out view of the small hole in cylinder(hole is also along the sectioned plane)

Shetty,
Using NX 10.0.1.4