Break Out Section line width

[andrzejd]

How can I change the line width in break out section view? When I change width before break out sectioning it changes nothing.

 

[andrzejd]

NX 8.5 version

 

[jerry1423]

Did you try printing it on a sheet of paper to see if it prints out with the line width that you want ?

 

[ewh]

...or viewing the drawing in monochrome display?

“Know the rules well, so you can break them effectively.”
-Dalai Lama XIV

 

[andrzejd]

I've exported it to pdf. The breakout line width is the same with standard line. I use 0.18mm for standard lines and I want to use 0,13 for breakout lines. I've drawn the spline and changed width to 0,13 and it's correct in printing, but when I made the break with that spile the width has changed.

 

[kapmnit123]

Hi,
If you right click the view (Style/Visible Lines) and change the width it updates properly for the break-out view.Is there something i am missing here?.
Best Regards
Kapil Sharma

 

[andrzejd]

I've attached the picture. I want to have the break out line more narrow then other lines.