Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

breakout view and broken view of a drawing

Status
Not open for further replies.
catsol

catsol

Mechanical
Nov 25, 2016
10
0
0
DE
is there a way to show both breakout and broken view of a drawing? if i use one, the other option greys out.In a long shaft, broken view used to reduce length and breakout view to show local section such as keyways.
 
Status
Not open for further replies.

Similar threads

John Jr
  • Locked
  • Question
Broken View Alignment 1
Replies
1
Views
4
MarcL68
MarcL68
Rich68
  • Locked
  • Question
2d Catalog Components orientation in drawing view
Replies
3
Views
8
Little Cthulhu
Little Cthulhu
Bombas
  • Locked
  • Question
msgcatalog - name changes of front view e.t.c.
Replies
2
Views
15
Bombas
Bombas
sri91
  • Locked
  • Question
Leader target as view
Replies
0
Views
7
sri91
sri91
BasicEngineer
  • Locked
  • Question
Automated Detailed View Generation - VBA
Replies
1
Views
15
Little Cthulhu
Little Cthulhu
Back
Top