Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

breakout view and broken view of a drawing

Status
Not open for further replies.
catsol

catsol

Mechanical
Nov 25, 2016
10
is there a way to show both breakout and broken view of a drawing? if i use one, the other option greys out.In a long shaft, broken view used to reduce length and breakout view to show local section such as keyways.
 
Status
Not open for further replies.

Similar threads

P
  • Question
Detail View - Section View
Replies
0
Views
907
Proportions
P
John Jr
  • Locked
  • Question
Broken View Alignment 1
Replies
1
Views
362
MarcL68
MarcL68
Chris Bills
  • Locked
  • Question
Catia 2D View Fix 2
Replies
3
Views
1K
Chris Bills
Chris Bills
Rich68
  • Locked
  • Question
2d Catalog Components orientation in drawing view
Replies
3
Views
337
Little Cthulhu
Little Cthulhu
Bombas
  • Locked
  • Question
msgcatalog - name changes of front view e.t.c.
Replies
2
Views
228
Bombas
Bombas

Part and Inventory Search

Sponsor

Back
Top Bottom