Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Broken views

Status
Not open for further replies.

AndyThody

Mechanical
Nov 2, 2007
8
0
0
GB
Hi all,
I have a detail of a shaft 2m long. In draughting I have 2 views of the shaft each view has a break in it. Is there an easy way of aligning the views and making both views the same length?
Andy.
 
Replies continue below

Recommended for you

Status
Not open for further replies.
Back
Top