Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

BULLET NOT MOVING 1

Status
Not open for further replies.
Oluwakay

Oluwakay

Mechanical
Joined
Sep 15, 2022
Messages
83
Location
PL
Hello Everyone,
Thank you for always helping out. I am trying to model a bullet impact, but when I run the simulation, the bullet is not moving at all.
What can I do? Is something wrong with my boundary condition?
 
Sort by date Sort by votes
Hard to say without knowing anything about the model but you should check the way you prescribe motion (usually initial velocity), step time settings, analysis progress (status file) and postprocessing settings (deformation scale factor, displayed frame, type of plot and so on).
 
Upvote 0 Downvote
I have been able to correct it. Thank you again!!!
 
Upvote 0 Downvote
I'm curious, what caused the problem ?
 
Upvote 0 Downvote
I applied a wrong BC to the bullet in the wrong step!
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

A
  • Question Question
Hinge Interconnection Not Working – Only One Shell Part Moves
Replies
7
Views
11K
adi@1234
A
Zivy98
  • Question Question
Why does the electrical potential not go the way I wanted?
Replies
3
Views
7K
FEA way
FEA way
F
  • Question Question
ABAQUS error - 'Node set assembly_left_rp' has not been defined
Replies
1
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran
B
  • Question Question
Abaqus natural frequency error with a tip mass, values not matching
Replies
11
Views
14K
boredbot
B
E
  • Locked
  • Question Question
ABAQUS IS NOT RUNNING THE MODEL
Replies
3
Views
3K
FEA way
FEA way

Part and Inventory Search

Sponsor

Back
Top