Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

bystronic 3015 laser cuts and then pauses

Status
Not open for further replies.

eldarcla

Mechanical
Mar 10, 2014
1
GB
We have a Bystronic 3015 laser that has developed an "error STL3511" over the weekend. It starts to cut then pauses and won't start again until the continue button is pressed. Does anyone have a clue where I could get the error code info as our machine came with the basic manual only.
 
Replies continue below

Recommended for you

Does this happen with both cutting head or just one? Does this happen with each program? What type of pierce and lead in/lead out are you using??
-HR
 
i don't know the codes but the ultrapack filter can cause something like this. The voltage signal out of it is only 18 volts and the logic controller don't like that.

Chris Krug Maximum Up-time, Minimum BS
 
STL3511 - Beam path air pressure is missing.
Check the ultra-pac unit for fault indication (led lights on side of unit) red light means it requires a service.(new filters)
Check the beam path air pressure regulator is set to 2bar.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top